Telephone Troubleshooting - Philips TD6831 Manuel D'utilisation

2uk onis suppl 19/07/01

Telephone troubleshooting...

PROBLEMS
The HANDSET icon does not flash
when the handset is placed on the charger.
No dial tone.
No ringer.
The icon is not displayed.
When adding a HANDSET to the BASE
STATION, a "Failure" message is displayed on
the HANDSET.
Interference during the call.
13
11:16 Page 13
REASONS
- Poor contact.
- Dirty contacts.
- No power.
- The HANDSET is not sufficiently charged.
- You are too far away from the BASE STATION.
The ringer is deactivated.
- The handset has not been registered.
- No mains power.
- The HANDSET is too far from the BASE
STATION.
The procedure used to add a HANDSET to
the BASE STATION has failed.
The maximum number of handsets (8) has been
reached.
- You are too far away from the BASE STATION.
- The BASE STATION is too close to
electrical appliances, reinforced concrete walls
or metal door frames.
Additional Onis 200 handset
SOLUTIONS
- Move the HANDSET slightly.
- Clean the contacts with a cloth moistened
with alcohol.
- Check connections.
- Charge the HANDSET.
- Move closer to the BASE STATION.
See "Ringer settings".
- Begin the handset registration procedure
again (page 5).
- Check connections.
- Move closer to the BASE STATION.
Disconnect and connect the BASE
STATION mains power supply. Begin the
handset registration procedure again (p. 5).
- Move closer to the BASE STATION.
Check the range.
- Move the BASE STATION to find a better
position (the higher the better).