Table of Contents
Advertisement
Operator Cab
Windshield Wiper / Washer Switch
This switch is available only on enclosed cab models.
Fig 58. Wiper Switch
Steering Mode Select Switch
DO NOT change steering modes until the forklift comes
to a complete stop. Align all four (4) wheels perpendicular
to the axle, before changing steering mode. Changing
steering modes at higher travel speeds can make the forklift
unstable, and cause a loss of control, which could result in
death, serious injury, or property damage.
The reach forklift includes three STANDARD modes of
steering:
· Two Wheel (2W)
· Four Wheel (4W) · Crab Steering
Fig 59. Steering Select Switch
Select the appropriate steering mode using the Steering
Select rocker switch. The status of this switch can be viewed
and/or monitored on the touchscreen, in the Steering Cluster
within the Main Switch cluster screen. This screen is accessed
from the Settings screen, touching the CAN Switches button.
See the SETTINGS - CAN Switches paragraph for mode details.
Warning
Multifunction Joystick Controller (Joystick)
The joystick is used to raise, lower, extend, retract the boom,
tilt the carriage (or attachment), and sway the machine frame.
Sway
Enable
Button
Joystick
Enable
Trigger
AUX
CONTROL
BOOM
FORK TILT
RETRACT
DOWN
SWAY
LEFT
FORK TILT
UP
AUX
CONTROL
Fig 60. Multifunction Joystick Controller (Joystick)
NOTE: The joystick is a variable speed control. Function
speed is proportional to handle movement. The more the
joystick is moved in the appropriate direction, the faster the
corresponding function will occur.
NOTE:
Increasing engine speed can increase boom lift,
extend, and carriage tilt speeds.
NOTE: Two (2) boom functions can be performed at the
same time by moving the joystick into the corner between (2)
individual functions (Positions B, D, F or H).
43
XR5519
Aux Button 1
Aux Button 2
Tilt Thumbstick
BOOM
EXTEND
SWAY
RIGHT
JOYSTICK
ENABLE
Operation Manual
18408-001
Advertisement
Table of Contents
