Xtreme Manufacturing Snorkel XR5519 Operator's Manual page 35

Operator Cab
NOTE: Refer to the Operation section on Warning Indicators
and Fault Codes.
G. ENGINE WARNING
The Engine Warning Indicator will be displayed when there is
an engine fault. Refer to the Operation section on Warning
Indicators and Fault Codes and the Engine Indicator Chart.
H. HIGH HYDRAULIC OIL TEMP
The hydraulic oil temperature indicator illuminates when the
oil temperature is above 1800 F. If the hydraulic oil temperature
indicator illuminates, stop and idle the engine to allow time for
cooling. If the hydraulic oil temperature indicator does not go
out after five (5) minutes, stop the forklift, follow proper shut
down procedures, tag the forklift with "Do Not Operate" tags,
and have a qualified mechanic service or repair the forklift
BEFORE placing it into service again.
I. WATER IN FUEL
The Water in Fuel Indicator will be displayed when water is
detected in the fuel filter. Drain the water by opening the
petcock on the bottom of the fuel filter.
J. FUEL GAUGE
Indicates the approximate quantity of fuel available in the
tank. The total capacity of the fuel tank is 17 gallons.
K. ENGINE TEMP GAUGE
Indicates the temperature of the coolant in the engine cooling
system. After starting the forklift, allow time for the tempera-
ture indicator to begin moving before operating the forklift.
After the engine has sufficiently been warmed up, normal en-
gine coolant temperature should read between 1800 to 2000 F.
L. OIL PRESSURE INDICATOR / WARNING
The Oil Pressure Indicator will turn yellow when the oil
pressure is below normal (between 20 and 10 psi). It turns
red under 10 psi. If the Oil Pressure Indicator comes on during
normal operation, stop the forklift, follow proper shut down
procedures, tag forklift with "Do Not Operate" tags, and have
a qualified mechanic service or repair the forklift BEFORE
placing it into service again.
M. BOOM ANGLE INDICATOR
Use the boom angle indicator to determine the boom angle
when referring to load capacity charts.
N. SPEEDOMETER
Analogously displays the machine traveling speed in miles per
hour.
O. OIL PRESSURE GAUGE
Displays the engine oil pressure on an analog gauge.
P. TACHOMETER
Indicates engine RPM on an analog gauge.
Q. ENGINE LOAD
Displays the percent of rated load for the current engine RPM
that is being applied to the engine.
R. VOLTAGE GAUGE
Indicates the amount of charge (in Volts). Normal system
voltage is between 12.5 and 14 Volts. If the voltage gauge
shows abnormal readings, stop the forklift, follow proper shut
down procedures, tag forklift with "Do Not Operate" tags, and
have a qualified mechanic service or repair the forklift BEFORE
placing it into service again.
S. MENU SELECTOR
Allows access to the MENU options.
T. SERVICE MENU
Enables access to the Service Menu.
U. ENGINE MAINTENANCE
Allows access to the ENGINE MAINTENANCE options.
Touching this icon opens a new screen depicting the
scheduled preventive maintenance mandated by the engine
manufacturer.
V. DAY/NIGHT DISPLAY MODE
This option dims the screen brightness to accommodate the
night forklift operation.
W. OPERATION MANUAL
Touch this icon to view the operator's manual.
X. HOUR METER
Indicates and records engine operating hours. Use the hour
meter to establish a forklift maintenance schedule.
Y. SCHEDULED MAINTENANCE INDICATOR
Illuminates when a scheduled maintenance task becomes
due.
35
XR5519
Operation Manual