Registration; Unregistration; Reset - Philips DECT7272S/05 User Manual

Registration

Up to 5 handsets can be registered to the base station.
Warning : If you wish to register non Philips handsets to the DECT 723 or DECT 727 base station,
make sure that this handset is GAP compliant otherwise it will not operate properly (see page 11).
To register a handset
If you have inadvertently unregistered your handset you can register it again.
Additional handsets must be registered to the base before use.
To register a handset, first press the paging key
base is in idle mode.Then carry out the following steps on the handset within one minute :
Press to reach the menu list.
Scroll to Adv. Settings and press
Scroll to Registration and press
Enter the 4-digit PIN code (by default "0000") and press
If the registration was successfull a long confirmation tone is heard and the handset
number (1 to 5) will be assigned by the base automatically.
To unregister a handset
Press to reach the menu list.
Scroll to Adv. Settings and press
Scroll to Unregistration and press
Choose the handset to unregister from the list and press
Note : Should you have your handset serviced, please make sure it is unregistered from the base station
before taking it back to the repair centre.
To reset to default settings
You can reset your phone to the default settings (see page 54) at any time . Note that after a
reset all your personal settings and saved data (phonebook entries, SMS messages,
call log and redial list) will be deleted.
Press to reach the menu list.
Scroll to Adv. Settings and press
Scroll to Reset and press
Select Yes to reset your phone and press
Note : After a reset you need to reconfigure your phone, refer to page 38.
on the base for approx. 5 seconds when the
SELECT.
SELECT.
SELECT.
SELECT.
SELECT.
SELECT.
Advanced Settings
OK.
SELECT.
SELECT.
45