Maintenance Cycle; Runtime Maintenance - Yueming CMA0604-B-A Product Operation Manual


As the materials to be processed are fabric, leather and other flexible materials, please clean the surface
of the cellular net with a brush after processing, or else it will affect the suction effect of the worktable
and thus affect the processing effect;

Cellular net should avoid contact with corrosive liquids or gases;

Damaged and deformed cellular net must be replaced.
4.4

Maintenance cycle


The maintenance period of laser, chiller and air compressor in accordance with the maintenance cycle
stated on the manual.

Lubricate the guide rail once every 15 days (1# viscosity coefficient lubricants recommended);

The cooling water of the chiller should be replaced once every 45 days (Watsons barreled pure water
recommended; prohibited to use tap water);

Optical lenses: Focus lens should be cleaned once every two days, and reflectors should be cleaned once
every two days;

The cutting wastes in the collection box should be cleaned once every six hours;
4.5

Runtime maintenance

Before running the machine tool, check machine tool every day as required. If there is abnormal sound when
the machine tool is running, shut down and check immediately. After the machine is running, shut down in
required sequence, clean the work table of the machine tool and around machine, and do not place unrelated
items on the work table or console of the machine.

Regularly check the lubrication of the moving parts of the machine tool, ensure sufficient lubrication of
X-axis rail, Y-axis rail, Z-axis rail and screw seat, ensure the accuracy of the machine tool, keep
lubrication of all moving parts and extend the life of X-axis, Y-axis and Z-axis rails;

Check the air pipe and water pipe for damage weekly; if damaged, inform Han's Yueming Laser for
maintenance;

Clean the debris and dust from the air inlet and outlet, and filter screen of the machine tool weekly;

Check the level of the cooling water weekly, and fill up in time if insufficient;

Check the pollution of the reflector and focusing lens surface every two weeks, and clean the optical
lens in time to ensure its service life;

Check the outer optical path once every month; the optical path directly affects the cutting results;

Check the filter in the gas path once every month, and remove the water and debris from the filter;

Regularly check if external cables are scratched, and if the interfaces in the power distribution cabinet
loose;

After the machine tool is installed and used for six months, readjust the level of the machine tool to
ensure the cutting precision.
48