Yueming CMA0604-B-A Product Operation Manual page 27


Water, electricity, exhaust air channels, sample material, computer and power socket relating to the
equipment should be prepared ready in advance by users.
Attention
3.1.4.1 Level adjustment of the machine
Measuring
point
Measuring
point
The level adjustment of the machine requires level meter of 0.02mm precision, the adjustment precision is
0.1mm, and the method follows:

First, adjust four feet to completely hold up the machine (casters off the ground);

Then, place a spirit level in the front of the machine, and observe the shift direction of the bubbles in
the spirit level. If the bubbles shift to the left, the left side of the machine is higher than the right side.
Please adjust the level of the machine by reducing the height of the left foot or increasing the height of
the right foot. When the bubble is centered in the spirit level, the front level of the machine has been
adjusted properly;

Then, adjust the level of the rear, left and right side successively in the same way. When the four
positions are adjusted, the machine level adjustment is finished, and the machine installation can be
continued.
The machine level adjustment is necessary. The subsequent operation of the machine will be
affected if the machine level is quite different.
Attention
22
During installation by our customer service personnel, the customer is required to
participate from the beginning to the end. Equipment installation and debugging are
parts of training, and the customers are required to learn them well.
Figure 3-6 Spirit Level Measuring Point Diagram
Measuring
point
Measuring
point
Spirit level