Troubleshooting Edvr Error Conditions; Edvr Error Condition With Ibcntl Set To 0Xe028002C (-534249428; Edvr Error Condition With Ibcntl Set To 0Xe0140025 (-535560155; Edvr Error Condition With Ibcntl Set To 0Xe0140035 (-535560139 - National Instruments GPIB-ENET Getting Started

Appendix D Troubleshooting and Common Questions

Troubleshooting EDVR Error Conditions

EDVR Error Condition with ibcntl Set to 0xE028002C (-534249428)

EDVR Error Condition with ibcntl Set to 0xE0140025 (-535560155)

EDVR Error Condition with ibcntl Set to 0xE0140035 (-535560139)

EDVR Error Conditions with ibcntl in the Range from 0xE1002710

(-520083696) to 0xE1002EE0 (-520081696)

EDVR Error Condition with ibcntl Set to 0xE1000054 (-520093612)

GPIB-ENET for Windows NT
Signaling, to determine which error is being reported and contact
National Instruments.
In some cases, calls to NI-488 functions or NI-488.2 routines may return
with the ERR bit set in
stored in is useful in troubleshooting the error condition.
ibcntl
If a call is made with a board number that is within the range of allowed
board numbers (typically 0 to 31), but which has not been assigned to a
GPIB interface, an EDVR error condition occurs with
0xE028002C. You can assign a board number to a GPIB interface by
configuring the NI-488.2M software and selecting an interface name. Refer
to Step 2. Configure the NI-488.2M Software Characteristics
Installation and Configuration, for information about how to configure the
NI-488.2M software.
If a call is made with a board number that is not within the range of allowed
board numbers (typically 0 to 31), an EDVR error condition occurs with
set to 0xE0140025.
ibcntl
If a call is made with a device name that is not listed in the logical device
templates that are part of the GPIB Configuration utility, an EDVR error
condition occurs with
These errors are returned from the WinSock Interface. The lower 16 bits of
specify the actual WinSock Interface error. Refer to your WinSock
ibcntl
Interface documentation for more information about the specific error.
You are attempting to communicate with a GPIB-ENET that does not have
a host name (IP address) specified in the GPIB Configuration utility. Refer
to Step 2. Configure the NI-488.2M Software
and the value EDVR in
ibsta
set to 0xE0140035.
ibcntl
D-2
. The value
iberr
set to
ibcntl
in Chapter 2,
Characteristics, in Chapter 2,
© National Instruments Corporation