Viavi T-BERD 5800 Testing Manual page 11

2. Setup
Screen
Connect:
Symmetry
L2 Network
Settings -
Local
L3 Network
Settings -
Local
RFC 2544
Tests:
Configuration
Templates
RFC 2544
Tests: Select
Tests
RFC 2544
Tests:
Utilization
RFC 2544
Teests: Frame
Lengths
RFC 2544
Tests:
Throughput
RFC 2544
Tests: Frame
Loss Test
Test Ctls:
Test Durations
Test Ctls:
Test
Thresholds
Use the
through the wizard and configure the remaining settings as follows:
Option
Throughput
Measurements
Frame Type
Encapsulation
VLAN ID
User Priority
Source IP Type
Source IP
Default Gateway
Subnet Mask
Destination IP
What type of IP
prioritization is used?
Do you want to use
a configuration template?
RCF 2544 Tests
Additional Tests
Bandwidth Unit
Maximum Bandwidth
Length Type
 Select 1
 If the MTU is greater than 1518
Packet Length
 Deselect (uncheck) all other packet
Zero-in Process
Measurement Accuracy
Test Procedure
Bandwidth Granularity
(L1Mbps)
Configure test durations
separately?
Duration
Number of Trials
Show Pass/Fail
Throughput Threshold
Throughput Frame Loss
Tolerance (%)
Latency RTD (µs)
Packet Jitter (µs)
Acterna Payload Version Version 3
Technical Support
or button at the bottom of the screen to advance
Value(s)
Symmetric
Loopback
DIX
See Work Order
See Work Order
0 (lowest)
See Work Order
See Work Order
See Work Order
See Work Order
See Work Order
None
No
 Throughput,
 Latency,
 Frame Loss
 Packet Jitter
L1 Mbps
See Work Order
Packet Length
st th th
, 4 , and 8 Frame Lengths.
(1522 with VLAN), also enter and
select the packet length of the MTU.
lengths.
Viavi Enhanced
To within 1 Mbps
RFC 2544 Standard
Enter minimum value:
 1 for 100Mbps Ethernet
 10 for Gigabit Ethernet
 100 for 10GigE
 400 for 40GiE
 1000 for 100GigE
No
120 seconds
1
Select all ()
See Work Order
See Work Order
See Work Order
See Work Order
tac@viavisolutions.com
Page 11 of 14
Comment
None or VLAN
Option only displayed if
Encapsulation = VLAN
Static or DHCP
Enter Committed Information Rate (CIR)
This will result in approximately 6
minutes of test time per frame length.
Enter CIR
Enter 0.0000
if not specified
Enter threshold in µsecs
(1 msec = 1000 µsec). Uncheck the
Show Pass/Fail box if a
threshold is not specified.
1-844-468-4284