olympia electronics GR-938/15L Quick Start Manual

WATERPROOF SELF-TESTING EMERGENCY LUMINAIRES
TECHNICAL CHARACTERISTICS
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERY (Ni-Cd)
BATTERY PROTECTION
INDICATIONS
CHARGING TIME
MINIMUM AUTONOMOUS DURATION
ILLUMINATION SOURCE
ILLUMINATION (MAINS / EMERGENCY)
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
Thank you for purchasing this product of Olympia
Electronics. A European manufacturer.
GENERAL
These luminaires are used in places where
emergency luminaires are needed. Each
luminaire must be permanently connected to
mains power supply. In normal operation the led
strip lights and the battery is charging. In case of
a mains power supply failure the luminaire will
light the led strip
mode. When the
restored the device turns to normal operation.
INSTALLATION
To install the luminaire follow the installation
instructions on page 2.
OPERATION
Battery Cut-off
The luminaire enters in this operation when the
mains power supply fails and battery has lost its
energy. During this operation the luminaire enters
the idle state and battery consumption is
negligible, in order to be protected from deep
discharge.
Battery charging
The battery charging is completely controlled. In
this case, is achieved the perfect
maintenance , as well as the elongation of its
duration. When the battery has completely
charged, it charges with a maintenance current.
Manual Test
The manual test can be conducted only if the
main power supply and the battery is connected.
By pressing the TEST/RESET button briefly (page
2) an operation test is initiated. During this test
period all indication LEDs are OFF.
Page 1 from 2
GR-938/15L
3.5W / 7.5VA
15 white LED's
105lm / 105lm
EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
automatically in emergency
mains power supply
High Quality European based Manufacturers
GR-938/30L
220-240V AC/50-60Hz
5W / 8.5VA
3.6V/1Ah
From overcharge and full discharge
Charge, lamp fault, fault indication LED
90min
30 white LED's
210lm / 210lm 210lm / 210lm
Bayblend FR3010, transparent polycarbonate
363 x 145 x 73 mm
790gr.
3 years (1 year for the battery)
Automatic test
This test includes all the operations that provide
the manual test and is conducted automatically
every 15 days. In order to be performed, the main
power supply and the battery should be connected.
Automatic Autonomous Test
The Automatic Autonomous Test is conducted and
measures the luminaire`s back up operation. This
test is conducted automatically every six months.
In order to be performed, the main power supply
and the battery should be connected (the battery
is should be charged). If the battery is not charged,
the test is postponed until the battery is completely
charged. If during the Automatic Autonomous Test
the luminaire's duration is lower than the named,
then the battery must be replaced.
Back Up Operation
The autonomous duration of battery during
emergency mode is at least the one that is stated
in the technical characteristics. During emergency
mode, a LED strip test is also performed.
Resetting Errors
Push the TEST/RESET button for 5 seconds, to
extinguish all the indicated LED errors (page 2).
Then the luminaire enters regular operation mode.
Indication LED status
battery
(with connected mains power supply).
Charge
On:
Οff:
disconnected battery).
Lamp fault
Οn:
Off:
Fault
Οff:
GR-939/15L
3.5W / 7.5VA
3.6V/1.5Ah
24h
180min
15 white LED's
105lm / 105lm
IP 65
o
0 to 40 C
Up to 95%
860gr.
Good charge current.
No battery (No charging current or
faulty LED strip.
Good LED strip.
Battery OK.
923939100_09_006
GR-939/30L
5W /8.5VA
3.6V/3Ah
30 white LED's
210lm / 210lm
920gr.