olympia electronics GR-940/15L/MAR Quick Start Manual

GR-940/15L/MAR
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERY (Ni-Cd)
BATTERY PROTECTION
INDICATIONS
CHARGING TIME
MINIMUM AUTONOMOUS DURATION
ILLUMINATION SOURCE
ILLUMINATION (MAINS / EMERGENCY)
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
Thank you for purchasing this product of
O l y m p i a E l e c t r o n i c s . A E u r o p e a n
manufacturer.

GENERAL

These luminaires, according to Lloyd's
Register Type Approval System are
s u i t a b l e f o r m a r i n e a n d o f f s h o r e
applications for use in environmental
categories ENV1, ENV2, ENV3 and ENV4,
where ENV1 are controlled environments,
ENV2 are enclosed spaces subject to
temperature, humidity and vibration, ENV3
are enclosed spaces subject to generated
heat from other equipment and ENV4 are
mounted on reciprocating machinery.
Each luminaire must be permanently
connected to mains power supply. In
normal operation the led strip lights and
the battery is charging. In case of a mains
power supply failure the luminaire will light
the led strip automatically in emergency
mode. When the mains power supply is
restored the device turns to normal

operation.

INSTALLATION

To install the
Installation Instructions on page 3.
OPERATION

Battery Charging

The battery charging
Page 1 from 2
WATERPROOF SELF TESTING EMERGENCY LUMINAIRES
TECHNICAL CHARACTERISTICS
EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3, IEC 60092-306, IEC 60533
luminaire follow
is completely
High Quality European based Manufacturers
220-240V AC/50-60Hz
3.6V/3Ah
From overcharge and full discharge
Charge, lamp fault, battery fault indication LED
15 white LED's
105lm / 105lm
5 to 40 C
Up to 95%
Bayblend FR3010, transparent polycarbonate
363 x 145 x 73 mm
3 years (1 year for the battery)
controlled. In this case, is achieved the
perfect battery maintenance , as well as
the elongation of its duration. When the
battery has completely charged, it charges
with a maintenance current.

Battery Cut-off

The luminaire enters in this operation when
the mains power supply fails and battery
has lost its energy. During this operation
the luminaire enters the idle state and
battery consumption is negligible, in order
to be protected from deep discharge.

Manual Test

The manual test can be conducted only if
the main power supply and the battery is
connected. By pressing the TEST/RESET
button briefly (page 3) an operation test is
initiated. During
indication LEDs are OFF.

Automatic Test

This test includes all the operations that
provide the manual test and is conducted
automatically every 15 days. In order to be
performed, the main power supply and the
battery should be connected.

Automatic Autonomous Test

the The Automatic
conducted and measures the luminaire`s
Back Up Operation. This test is conducted
automatically every six months. In order to
be performed, the main power supply and
4W/7VA
24h
480min
IP 65
o
945gr.
this test
Autonomous
923940002_09_003
period all
Test is