Table of Contents
Advertisement
5.
Place the hearing device close to the Roger iN microphone (within 10 cm / 4 inches)
6.
Wait approximately 5 seconds until the indicator light on the Roger iN microphone turns solid green
7.
Repeat step 2. to 6. with the second hearing device.
Note: The hearing device(s) will automatically be connected to the Roger iN microphone.
In case the indicator light turns red after the installation procedure, the installation was not successful. This could be for the
following reasons:
-
The distance between the Roger iN microphone and the hearing device was too far
-
There are no Roger receivers installed on the Roger iN microphone
-
The hearing device already has Roger installed
-
The hearing device is not RogerDirect compatible.
Checking number of Roger receivers in a Roger iN microphone
After turning on the Roger microphone, briefly press the install button on the Roger iN microphone:
Roger Select iN
The indicator light feedback will tell you the number of installed Roger receivers:
Two Roger receivers installed
One Roger receiver installed
No Roger receiver installed
Roger Table Mic II iN
Roger Pen iN
Phonak Roger iN microphone installation guide
2
Advertisement
Table of Contents
Need help?
Do you have a question about the Roger iN and is the answer not in the manual?
Questions and answers