Advertisement
Phonak
Roger™ iN microphones
Roger iN microphone installation guide
Contents
Installing Roger receivers into a pair of hearing devices with RogerDirect™ ............................................................................................. 1
Checking number of Roger receivers in a Roger iN microphone .................................................................................................................... 2
Uninstalling Roger receiver from a hearing device ............................................................................................................................................ 3
Installing Roger receivers into a pair of hearing devices with RogerDirect™
Make sure the hearing instrument contains the latest FW that is available in Phonak Target 6.1 or higher.
Installation steps:
1.
Switch on the Roger iN microphone
2.
Press and hold the install button for two seconds until the indicator light starts to blink green:
Roger Select™ iN
3.
Place the Roger iN microphone on the table
4.
Switch on one hearing device (keep other hearing devices switched off)
Roger Table Mic II iN
Roger Pen™ iN
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Phonak Roger iN
Summary of Contents for Phonak Roger iN
- Page 1 Uninstalling Roger receiver from a hearing device ............................3 Installing Roger receivers into a pair of hearing devices with RogerDirect™ Make sure the hearing instrument contains the latest FW that is available in Phonak Target 6.1 or higher. Installation steps:...
- Page 2 Place the hearing device close to the Roger iN microphone (within 10 cm / 4 inches) Wait approximately 5 seconds until the indicator light on the Roger iN microphone turns solid green Repeat step 2. to 6. with the second hearing device.
- Page 3 Switch on one hearing device (keep other hearing devices switched off) Place the hearing device close to the Roger iN microphone (within 10 cm / 4 inches) Wait approximately 5 seconds until the indicator light on the Roger iN microphone turns solid green Repeat step 2 to 6 with the second hearing device if needed.
Need help?
Do you have a question about the Roger iN and is the answer not in the manual?
Questions and answers