Adjustments; Suspension Adjustments Guideline; Suspension Factory Settings - BRP Can-Am Commander 2014 Series Predelivery Bulletin

vmr2006-012-100_ben
WRITE DATA BUTTON
2. Click on EXIT button to end session.
3. Disconnect all cables and hardware from vehi-
cle.
4. Ensure to reinstall the connector into its hous-
ing.

ADJUSTMENTS

All adjustments have already been performed at
factory, it is only necessary to validate them.
Suspension Adjustments
Guideline
Vehicle handling and comfort depend upon sus-
pension adjustments.
WARNING
Suspension adjustment could affect vehicle
handling. Always take time to familiarize
yourself with the vehicle behavior after any
suspension adjustment has been made.
ADJUSTMENT
Spring preload
Compression damping
(low speed)
Compression damping
(high speed)
Rebound damping
PREDELIVERY
FRONT SUSPENSION FACTORY SETTINGS
MODEL
Base
DPS
XT
XT-P
LTD
XT-P
LTD
XT-P
XT-P
2014-2
Choice of suspension adjustments vary with ve-
hicle load, personal preference, riding speed and
terrain condition.
The best way to set up the suspension, is to start
from factory settings, then customize each adjust-
ment one at a time.
Front and rear adjustments are interrelated. It
may be necessary to readjust the rear shock ab-
sorbers after adjusting front shock absorbers for
instance.
Test run the vehicle under the same conditions;
trail, speed, load, etc. Change one adjustment
and retest. Proceed methodically until you are
satisfied.
Following are guidelines to fine-tune suspension.

Suspension Factory Settings

For adjustment procedures, refer to
PRELOAD ADJUSTMENT (FRONT AND REAR)
and SHOCK DAMPING ADJUSTMENTS (FRONT
AND REAR)
in this section.
To adjust compression and rebound to factory set-
tings, proceed as follows:
1. Turn adjuster clockwise until it stops.
2. Turn adjuster counter clockwise by the speci-
fied amount, see table below.
FACTORY SETTING
Cam position 1 (soft)
Spring length 310 mm (12.2 in)
Not adjustable
12 positions
10 positions
12 positions
12 positions
ADJUSTMENTS
SPRING
41 / 54