Omron CJ Series Manual page 20

Setting of External Device
For communication settings of the communication unit, you need to register the serial communication unit to be
used by the ladder software in advance.
After registration, open [I/O Table] of the ladder software. Click [Switch] from the menu displayed by right-
clicking [Serial Communication Unit] and set as below.
Setup Items
Line Speed
Parameter
Mode
Send Delay Time
CS Control
Unit No. Setting Rotary Switch
Unit No.
Source Network Address
Node Address Setting Rotary Switch
*1 You need to set this switch to the same value as "CPU High Function Unit No." of the serial communication
unit in the I/O table assigned by the ladder tool.
*2 Parameter used when you access beyond network. Set in the routing table of "CX-Net Network Configuration".
Please refer to the manual of the External Device for more details.
*3 Parameter used when you access beyond network. Set with the rotary switch on the front of the Controller Link
unit used for access beyond network.
Notes
• Do not set the duplicate node address in the same network address group.
GP-Pro EX Device/PLC Connection Manual
19200
1,7,2,E
Default (HOST Link)
0
None
*1
Same value as "CPU High Function Unit No."
Option
*2
Option
*3
Option
Settings
20
CS/CJ Series HOST Link Driver