Models Prs-1 And Prp-1 (110-120V, 1 Phase) - InSinkErator PowerRinse PRP Series Installation, Care And Use Manual

Models PRS-1 and PRP-1 (110-120V, 1 Phase) Wiring Diagram
ELECTRICAL SHOCK
• Turn off all electrical supply to the collector before
attempting any work on it. Use a voltmeter or
circuit tester to ensure that power is off.
• Installation must conform to local electrical codes.
• All control centers and collector components must
be carefully and permanently grounded.
• A properly fused disconnect must be installed at
the electrical supply source for the control center.
120 V
110-120 V
1-phase
1 Phase
1/2 to 2 HP
Call Toll Free 1-800-845-8345
for the nearest InSinkErator
Authorized Service Agency or
to reach Technical Support.
PROPERTY DAMAGE
• Ensure that the control center voltage and phase
match the pump and electrical supply. Reference
the nameplates for voltage and phase.
• The pump motor wiring diagram is shown on the
casing of the pump.
Note: Black wires = Line voltage (110 - 120 V).
16