Updating The System Firmware Level Of A Bmc Card To Op940.20, Or Later, In An 8335-Gth Or 8335-Gtx System - IBM OpenCAPI Installing And Servicing

Figure 40. Power cord loop with sidewall routing
4. Close the rack door at the rear of the system.
Updating the system firmware level of a BMC card to OP940.20, or
later, in an 8335-GTH or 8335-GTX system
To update the system firmware level of a BMC card to OP940.20, or later, complete the steps in this
procedure.
Procedure
1. Are you able to connect the BMC card to the network with a Dynamic Host Configuration Protocol
(DHCP) IP address?
If
Yes
No
Common procedures for servicing or installing features in the 8335-GTC, 8335-GTG, 8335-GTH, 8335-GTW, or
Then
Update the system firmware level of the BMC card to OP940.20, or later. For
instructions, see Updating the system firmware by using the OpenBMC tool. If you are
not able to update the system firmware level, continue with the next step.
Continue with the next step.
8335-GTX system 53