Fuse Replacement - Toyota 7FBCU20 Owner's Manual

V.
OPERATOR MAINTENANCE
FUSE REPLACEMENT
1 .5-3.2 ton models
3.5-5.5 ton models
1.5-3 2 ton models
(Option: Load handling chopper)
1 5-3 2 ton models
(PS contactor)
If a lamp does not come on or an electrical device does not function, the
corresponding fuse may have blown.
Check the fuse for each device. The fuse location is shown in the picture above.
111111111111111111111111III111111111111111111IIIlllllllllII
WARNING
Separate the battery plug.
Disconnect the battery plug before
you attempt t o replace a fuse.
Replace fuses with the same
capacity as the bad fuse. Fuse
specifications are found i n the
Service Data Section.
If the fuse tends t o burn out fre-
quently, never attempt to use wire,
tin foil, or other substitutes. Ask
your Toyota dealer t o inspect and
repair.
1111111111111111111llllllllllllllllllllllllllllllllllllllll
Note
See the table below for the device
Fuse Assignment
F1 Drive Motor
F2 Pump Motor
F3 Power Steering Motor
F4 Lamps
F5 Control Circuit
F6
Controller
F7 ST controller
Check Service Data Section for proper
fuse amp rating