Pool Draining; Storage - Intex GRAPHITE GRAY PANEL POOL SET 15'8" Owner's Manual

POOL MAINTENANCE & DRAINAGE
CAUTION
Do not add chemicals if the pool is occupied. This can cause skin or eye irritation. Concentrated
chlorine solutions can damage the pool liner. In no event is Intex Recreation Corp., Intex Development
Co. Ltd., their related companies, authorized agents and service centers, retailers or employees liable to
the buyer or any other party for costs associated with the loss of pool water, chemicals or water damage.
Keep spare filter cartridges on hand. Replace cartridges every two weeks. We recommend the use
of a Krystal Clear™ Intex Filter Pump with all of our above-ground-pools. To purchase an Intex Filter
Pump or other accessories see your local retailer, visit our website or call the Intex Consumer
Services Department listed in the separate "Authorized Service Centers" sheet and have your Visa
or Mastercard ready.
EXCESSIVE RAIN: To avoid damage to the pool and over filling, immediately drain rain water that
causes the water level to be higher than the maximum.
How to Drain Your Pool and Long Term Storage
1. Check local regulations for specific directions regarding disposal of swimming pool water.
2. Check to make sure that the drain plug inside the pool is plugged in place.
3. Remove the cap from the drain valve on the outside pool wall.
4. Attach the female end of the garden hose to the drain connector.
5. Place the other end of the hose in an area where the water can be safely drained away from the house
and other nearby structures.
6. Attach the hose adapter to the drain valve. NOTE: The adapter will push the drain plug open inside
the pool and water will start to drain immediately.
7. When the water stops draining, start lifting the pool from the side opposite the drain, leading any
remaining water to the drain and emptying the pool completely.
8. Disconnect hose and adapter when finished.
9. Re-insert drain plug in drain valve on inside of pool for storage.
10. Replace drain cap on outside of pool.
11. Reverse set-up instructions to disassemble the enclosure and pool, and remove all connecting parts.
12. Be sure that the pool and all parts are completely dry before storage. Air dry the liner in the sun until
completely dry before folding (see drawing 17). Sprinkle talcum powder to prevent vinyl from sticking
together and to absorb any residual missed.
13. Create a square shape. Starting at one side, fold one-sixth of liner in on itself twice. Do the same on the
opposite side (see drawings 18.1 & 18.2).
14. Once you have created two opposing folded sides, simply fold one over the other like closing a book (see
drawings 19.1 & 19.2).
15. Fold two long ends to the middle (see drawing 20).
16. Fold one over the other like closing a book and compact the liner (see drawing 21).
17. Store the liner and accessories in a dry, temperature controlled, between 32 degrees Fahrenheit
(0 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius), storage location.
18. The original packing carton can be used for storage.
17
19.1
SAVE THESE INSTRUCTIONS
ALWAYS FOLLOW THE CHEMICAL MANUFACTURER'S
DIRECTIONS, AND THE HEALTH AND HAZARD WARNINGS.
18.1 18.2
19.2 20
(120PO) ENGLISH 7.5" X 10.3" PANTONE 295U 10/10/2018
English
21
120
PO
Page 22