Table of Contents
Advertisement
5
Installing the Fuse
4WD Switch Only
Parts needed for this procedure:
1
Fuse (10 A)
1
Fuse decal
Procedure
Important:
This procedure is necessary if you
are going to install the 4WD switch.
1.
Install the fuse into the C4 slot in the fuse box
(Figure
17).
Note:
If another fuse is already occupying the
C4 slot, place the fuse in any open auxiliary slot.
Figure 17
1. C4 Slot
2. Fuse
Important:
Note which fuse slot
corresponds to which auxiliary power wire.
If the switch is connected to a wire without a
fuse, it will not function.
2.
Place the fuse decal in the corresponding panel
of the fuse map decal located under the toolbox
cover.
g205019
3. Auxiliary slot
Fuse decal in C4 slot, previous model machines
1. C5 Auxiliary slot
Fuse decal in C3 slot, new model machines
1. C3 Auxiliary slot
13
Figure 18
2. C4 Auxiliary slot with decal
Figure 19
g206710
g312777
Advertisement
Table of Contents
