Table of Contents
Advertisement
6
Installing the Switch
Parts needed for this procedure:
1
Toggle switch
1
Switch wire harness
1
4WD function decal
1
Relay wire harness
1
Relay
1
Self-tapping screw
Procedure
1.
Drill a 13 mm (1/2 inch) hole in the center
console; refer to
orientation.
Important:
Use caution to not contact
any components or wires underneath the
console with the drill bit.
Figure 20
1. 13 mm (1/2 inch) diameter
2. 13 mm (1/2 inch) from
the center of hole to the
right edge of the high-low
speed control switch
Figure 20
for the appropriate
3. 25 mm (1 inch)
2.
Place the 4WD function decal over the drilled
hole
(Figure
3.
Identify the switch terminal locations, wire
harness labels, and wire harness colors
22).
The switch terminals are identified by the
numbers imprinted into the bottom of the switch.
Note:
The switch is spring-loaded to the rear of
the switch
open between terminals 1 and 2
g034547
Installed switch orientation
1. Terminal 1—rear
2. Terminal 2—center
14
21).
Figure 21
(Figure
23). The switch is normally
(Figure
Figure 22
3. Terminal 3—front
g205310
(Figure
22).
g273505
Advertisement
Table of Contents
