Operation - Yard force GT5664 Original Instruction

Charging the battery(Fig 10)
WARNING! Observe correct mains voltage: The voltage of the power source
must comply to the voltage specified on the nameplate of the unit. Equipment
marked with 230V can also be connected to 220V or 240V.
WARNING! Use only the charging unit supplied. Only this charging unit is
matched to the lithium battery used in the product.
WARNING! The battery is supplied partially charged, to ensure full capacity of the
battery, completely charge the battery in the battery charger before using your
power tool for the first time.
WARNING! It will keep longer life of the battery if always leave it fully charged
when kept the charger for storage.
The charging procedure is only possible when the battery temperature is within the
allowable charging temperature range see section "Technical Data".
1. Connect the charger into the electric outlet and the LED light will be on, which shows
the charger is ready for charging.
2. Insert the battery pack into the charger and then the LED light will be flashing, which
means the during the charging processing. And at the same time 4 LED on battery
pack is flowing lighting.
3. When fully charged the 4 LED will be all light for 3 seconds and shut down. And the
LED on charger stops flashing and keeps on.
Fig 10
Indicator LED on charger
a. When the charger is pluged on, the green LED lights.
b. When the battery pack is inserted into the charge and connect correctly, begin to charge
the battery pack, the green LED is flashing
c. When the battery pack is fully charged the green LED lights permanently.
d. If any problems the red LED will be flashing.
WARNING!
When the battery pack is fully charged, it is recommended that the battery pack
should be taken off the charger immediately to prevent the overcharge.

OPERATION

a
18
c d
b