Table of Contents
Advertisement
PREPARATION
1.
Clean, level and prepare the floor for installation.
2.
Place the unit in the exact installed position on the floor
and trace the outline of the bath with a pencil or any
erasable marking (figure 1).
3.
Determine the location of the drain pipe, on the floor by
taking measurements of the drain and waste location
underneath the unit (figure 2).
4.
Using a blanket, cardboard, or other clean protective
surface, turn the unit on its side so that the unit is properly
supported during drain installation.
5.
Clean the drain hole area in preparation of setting the
drain. The area should be dry and free of any debris.
INSTALLATION
INSTALL DRAIN HARDWARE
6.
7.
Figure 1
8.
9.
Figure 2
Apply a bead of clear silicone or plumbers putty around
the Drain Body and pass it through the drain hole (figure
3).
Apply plumbers putty to the Washer and slide it over the
bottom of the Drain Body (figure 3).
Slide the paper washer over the drain body.
Attach the Drain Body Nut on the Drain Body and
tighten until the Nut and Washer have created a seal
with the bottom of the bathtub. DO NOT OVERTIGHTEN
(figure 4).
Figure 3
PUTTY
or
SILICONE
Figure 4
Advertisement
Table of Contents
