* Run pump only when water in tub is two inches over jets. The plumbing system on all Access Tubs meets ETL, and ANSI standards at time of manufacture. Any modifications to the plumbing system, including the pump, will void the warranty and approvals.
Check color compatibility with other fixtures. Check to insure that the bath has the proper components. Access Tubs will not be held responsible for tub damage or color compatibility problems after whirlpool is installed. Access Tubs will not be held responsible for cost of installation or repair if an incorrect tub is installed.
A second GFCI circuit of NOTE: On some models, the pump may exceed beyond the 15 Amps if needed for the Inline Heater. An access panel must perimeter of the tub. If you have such a model, please make be installed to permit pump service.
Page 6
Provide supply pipe, rough-in waste and vent per code. Before finishing with your choice of material, make sure access entries are available to the pump, bath waste, and PLUMBING plumbing fixtures. Finish as desired and seal around tub, pref- PVC Schedule 40 piping, self draining pump and fittings come erably with silicone.
Page 7
CONTINUED TYPICAL INSTALLATIONS Make absolutely certain that access panels and/or service openings are properly placed and that all possible areas where service may be required are accessible. TUB TO BE SUPPORTED BY THE SUPPORT BASE AND BEDDING, NOT BY THE LIP OF TUB...
Page 8
INSTALLATION CONTINUED ACCESS TOUCH PLUS START UP AND OPERATIONAL INSTRUCTIONS Pump On/Off: 1st Press - the pump starts 2nd Press - the pump stops Blower On/Off: 1st Press - the blower starts 2nd Press - the blower stops Air Jet Speed (INCREASE)
INSTALLATION CONTINUED 120V/60Hz Variable Blower & On/Off Pump ELECTRICAL FEEDER 120V/60Hz 120V 15A Tee-Heater 120V 20A for Blower/Pump GROUND FAULT GROUND FAULT CIRCUIT INTERRUPTER CIRCUIT INTERRUPTER CLASS A CLASS A CONTROL EVO2-T-CB/L-P1B2/12/3-WD1+VB24 WATER DETECTORS FOR PUMP CHROMATHERAPY LIGHT BLUE B-CORE for Blower Tee-Heater 120/60 8.3A...
USER SHOULD periodically flush operating system (not to exceed 90 days). As a minimum, shall consist of filling and running system and draining. Access Tubs recommends flushing with a mild solution of water and sanitizer such as chlorine or other commercially available whirlpool bath flushing products.
Page 11
WARRANTY PERFORMANCE In the event of any defect in workmanship or materials covered under Access Tubs will not be liable for loss of use of the Atlantis Whirlpool the terms of the “Bath Shell” warranty, Access Tubs will repair the...
NOTES INSTALLER INFORMATION DATE OF INSTALL: INSTALLER’S NAME: PLUMBER: CONTRACTOR: LICENSE #:...
Page 14
Record the numbers here for handy reference: Model No. Serial No. Date of Purchase M a d e i n Manufactured by Access Tubs A Division of Spa World Corp. 5701 NW 35th Avenue U S A Miami, Florida 33142 Ph: 877.249.2388 • Fax: 866.560.1060 Email: info@accesstub.com...