Table of Contents
Advertisement
PLUMBING ROUGH-IN
The bath waste opening protrudes below the base approx-
imately one inch. You may be required to cut a hole in the
subfloor to accommodate bath waste. In slab on grade or
prestressed concrete floors where cutting is not desired, the
tub may be raised up by building the platform higher and
using extra mortar under the tub. If a joist must be notched,
verify that structure will not be weakened. Remove only
what is necessary. Provide supply pipe, rough-in waste and
vent per code.
PLUMBING
PVC Schedule 40 piping, self draining pump and fittings
come completely preplumbed unless requested otherwise.
The pump and whirlpool system are completely contained
within the tub perimeter.
Standard GFCI 110V, 20 Amps
Blower Electrical Supply
INSTALLATION
CONTINUED
INCOMING POWER ELECTRICAL
Dedicated 110v 20 AMP GFCI with 3 outlets, one for each
component (pump, blower, chromalight). Ground Fault
Circuit Interrupter (GFCI) is required. The GFCI breaker
must not supply any other circuits or devices.
FINISHING
Before finishing with your choice of material, make sure
access entries are available to the pump, bath waste, and
plumbing fixtures. Finish as desired and seal around tub,
preferably with silicone.
NOTE:
1.
For Caulking, we recommend 100% sanitary silicone
rather than latex.
2. For quieter operation, you may choose to insulate the
construction area.
3. IT IS THE INSTALLERS RESPONSIBILITY TO
SUPPLY ACCESS TO PUMP AND EQUIPMENT
REMINDER: During construction, we suggest that you
cover tub to avoid use as trash receptacle.
NOTE: To service the blower and other electrical
components the caulking must be removed. Afterwards
the skirt should be cleaned and caulking reapplied.
Advertisement
Table of Contents
