Safety Instructions - tams elektronik EasySound mini Manual

English
Required materials
In order to play the sounds you need:

a loudspeaker with an impedance of a minimum 32 Ohm and a
rated load-carrying capacity of 0,1 Watt;
If you want to release or interrupt the playback automatically you need:

reed contacts with one normally-open contact (e.g. item no. 84-
53110-10) and / or

Hall-sensors (e.g. item no. 84-53210-01) and

permanent magnets (e.g. Neodym magnets Ø 3mm, thickness =
2 mm, item no. 84-53990-10).

2. Safety instructions

Mechanical hazards
Cut wires can have sharp ends and can cause serious injuries. Watch
out for sharp edges when you pick up the PCB.
Visibly damaged parts can cause unpredictable danger. Do not use
damaged parts: recycle and replace them with new ones.
Electrical hazards

Touching powered, live components,

touching conducting components which are live due to malfunction,

short circuits and connecting the circuit to another voltage than
specified,

impermissibly high humidity and condensation build up
can cause serious injury due to electrical shock. Take the following
precautions to prevent this danger:

Never perform wiring on a powered module.

Assembling and mounting the kit should only be done in closed,
clean, dry rooms. Beware of humidity.
Page 4
EasySound mini