Check List For Troubleshooting - tams elektronik EasySound mini Manual

EasySound mini

8. Check list for troubleshooting


Parts are getting too hot and/or start to smoke.
Disconnect the system from the mains immediately!
!
Possible cause: the module is defective. à Send in the module for
repair.

The loudspeaker hums.
Possible cause: The supply voltage the vehicle decoder can supply is
too low. à Connect a buffer capacitor (min. 100 µF / 25 V) to the
module (see section 6.)

After switching on a function key no sound is to be heard.
Possible cause: The loudspeaker is connected incorrectly.  Check
the connections.
Possible cause: The EasySound mini is not connected correctly to the
SUSI interface.  Check the connections.
Possible cause: The corresponding sound file is blank or does not
exist.  Check the file and the file name.
Possible cause: The switching input #2 is connected to a function
output of the decoder and the corresponding function is switched
on.  Switch off the function.

After passing a permanent magnet no sound is to be heard.
Possible cause: The distance to the magnet is too large or the
magnet is too weak.  Alter the position of the magnet (if possible)
or use a stronger one.
Possible cause: The magnet has been mounted incorrectly polarized.
 Alter the mounting direction.
English
Page 21