Electro-Voice EBK1-M10-3PACK Installation Notes page 9

4.
Mounting a U-Bracket to the wall or ceiling
The U-Bracket is used to mount a loudspeaker to the wall or ceiling.
Caution!
Due to the weight of the Electro-Voice loudspeaker system, it is imperative the bracket is
!
properly secured to the wall. The choice of fastener (not supplied) will be determined by the
material and construction of the mounting surface. The user is responsible to ensure the
mounting surface and fasteners are capable of supporting the weight of the loudspeaker.
Caution!
! Two person lift and placement is recommended for the heavier loudspeakers. Single person
lift and placement of heavier loudspeakers could cause injury.
U-Bracket mounting options
A
A: For wall mounting with bolts (3/8" or M10 bolts) OR pole/truss mounting with U-bolts (2"
or M10 U-bolt) (4 PLS)
B: For ceiling mounting with threaded rods (1/2" or M16 threaded rods) (2 PLS)
C: For ceiling mounting with U-bolt (4" or M16 U-bolt) (2 PLS)
D: For ceiling mounting with threaded rods (3/8" or M10 threaded rods) (2 PLS)
Electro-Voice
Using the four screws you removed from the top handle, attach the upper mount (B) to a
15 inch loudspeaker where the top handle was located in the down position.
A
C
ELX200-10/10P
Using the four screws you removed from the bottom handle, attach the lower mount (D)
to a 12-inch or 15-inch loudspeaker where the bottom handle was located in the up
position.
OR
Using the four screws you removed from the bottom handle, attach the lower mount (C)
to a 10 inch loudspeaker where the bottom handle was located in the down position.
B
A
D
ELX200-12/12P
C
D
Installation note
en 9
B
D
ELX200-15/15P
2017.12 | 02 | F.01U.332.445