Electro-Voice EBK1-M10-3PACK Installation Notes page 8

ELX200 Full-Range Loudspeaker Accessories
Installing the mounts
The ELX200 wall mount bracket is designed for use with all of the ELX200 full-range
loudspeakers.
Notice!
When mounting a loudspeaker horizontally, the lower mount needs to be installed with the
slot opening on the bottom. This may require the upper/lower mounts to be switched
between the top and bottom of the loudspeaker.
A
Figure 2.1: Horizontal mounting slot orientation with the lower mount slot opening on the bottom (A)
To attach the mounts to a loudspeaker, do the following:
1.
2.
3.
2017.12 | 02 | F.01U.332.445
Using a screwdriver, remove the four screws holding the top (A) handle to the chassis.
Keep these screws to assemble the upper mount.
A
B
Remove the four screws holding the bottom handle (B) (where applicable) to the chassis.
Keep these screws to assemble the lower mount.
Using the four screws you removed from the top handle, attach the upper mount (A) to a
10 inch or 12 inch loudspeaker where the top handle was located in the up position.
OR
Installation note Electro-Voice