Storage - Silvercrest SMAS 600 A1 Operating Instructions Manual

Clean the container 4 immediately after it has cooled down each time you use it
to prevent the milk residue from drying on . Proceed as follows:
♦ For initial basic cleaning, fill the container 4 with water and, if required, a
little detergent (the whisk 3 is inserted) . While doing so, note the MIN and
MAX - markings
♦ Start the appliance so that the whisk 3 swirls through the water for a while .
Afterwards, rinse the appliance out with clean water .
For a thorough cleaning and for the initial cleaning, proceed as follows:
♦ Remove the whisk 3 from the appliance and clean the inside of the
appliance with warm water and mild detergent if required . Wipe the interior
out with a soft cloth or sponge . Pay special attention to the area around the
drive shaft . Afterwards, rinse out the appliance thoroughly with clean water
and dry it .
♦ Pull the sealing ring 2 off the lid 1 and clean both parts in mild soapy
water . Rinse off detergent residues with fresh water and dry the parts well .
Push the sealing ring 2 back onto the lid 1 .
♦ Clean the whisk 3 in mild soapy water and then rinse it thoroughly with
fresh water . Allow it to dry .
♦ Clean all exterior surfaces, the base 7 and the mains cable with a slightly
damp cloth . For stubborn soiling, use a mild detergent on the cloth . Wipe
off any detergent residues using a cloth moistened only with clean water .
Always dry the appliance thoroughly before using it again .

Storage

♦ Allow the appliance cool down completely before putting it into storage .
♦ Wind the power cable around the cable retainer 8 in a clockwise direction .
♦ Store the appliance in a clean and dry location .
SMAS 600 A1
(= 300 ml) .
GB │ IE │ NI │ CY │
11 ■