Throttle Trigger / Lockout Lever (Ms 201 T) - Stihl MS 201 Manual

1
: Push leg (1) of torsion spring in
direction of rear handle.
: Press the lockout lever (2) into
the mounts until it snaps into
place.
1
: Attach the torsion spring (1) to
the lockout lever (arrow).
1 2
2
: Push the lugs (1) of the handle
molding (2) under the projections
(arrows).
– Push down the handle molding
until it snaps into position.
MS 201, MS 201 C, MS 201 T, MS 201 TC
– Check operation
– Throttle trigger must be
blocked when the lockout lever is
not operated and the switch lever
must be blocked in the direction
2
of cold start when the throttle
trigger is not operated.
– Reassemble all other parts in the
reverse sequence.
10.3 Throttle Trigger /
Lockout Lever (MS 201 T)
1 1 2
: Take out the screws (1).
: Carefully remove the handle
molding (2) – rods and levers
may fall out.
1
: Pull out the throttle rod (1) and
choke rod (2), b 10.3.2
: Remove the lockout lever (1) and
throttle trigger (2).
1
1
: Disconnect the torsion spring (1)
from the throttle trigger (2).
– Check individual parts, replace if
necessary
Installing
1
2
: Fit and connect torsion spring (1)
– note installed position (arrow).
1
2
2
77