Pawls - Stihl MS 201 Manual

8.3

Pawls

– Remove the fan housing, b 8.2
– Relieve tension of rewind spring,
b 8.4
: Carefully ease the spring clip (1)
off the starter post.
– Pull the pawl out of the rotor.
Installing
2
: Lubricate seat (short arrow) with
STIHL multipurpose grease,
b 14
: Push the bearing pin (2) of
pawl (1) into its seat (arrow).
60
: Position the spring clip (1) so that
1
its loop engages the peg on the
pawl. The rounded part of the
spring clip (short arrow) must
engage the starter post's groove.
: Push the straight part of the
spring clip over the starter post
until it snaps into the groove.
1
The spring clip's guide loop must be
in line with the pawl (arrow).
Check operation
– Pull the starter rope, the rotor
turns and the peg on the pawl
moves in the direction of the
spring loop – the pawl moves
outwards.
– Reassemble all other parts in the
reverse sequence.
Models with ErgoStart
Two pawls are installed in models
with ErgoStart. The removal
1
procedure is the same as for the
standard version.
– Lubricate seats of new pawls with
STIHL multipurpose grease,
b 14
– Lubricate pegs of new pawls with
STIHL multipurpose grease,
b 14
Installing
2
1
Make sure the washer (1) is in
place.
: Position the spring clip (2) so that
its loops engage the pegs on the
pawls. The rounded part of the
spring clip (arrow) must engage
the starter post's groove.
: Push the straight part (3) of the
spring clip over the starter post
until it snaps into the groove.
– Reassemble all other parts in the
reverse sequence.
MS 201, MS 201 C, MS 201 T, MS 201 TC
3