Table of Contents
Advertisement
SAFETY NOTICES
Chapter 5 – Safety Notices
Installation Safety
This information is also available in the Installation Guide.
Warnings and
Warning and Caution symbols mean potential danger. You are in a situation that could cause bodily injury. Before
working on any equipment, be aware of hazards in the installation area and be knowledgeable about electrical
circuitry. Be familiar with standard practices for preventing accidents.
For translations of key cautions and warnings, refer Appendix A.
Warning:
Only trained and qualified personnel should install, replace, or service this equipment. Installation
must comply with local and national electrical codes.
When installing or replacing the unit, the ground connection must always be made first and
disconnected last.
Disconnect POE power (Ethernet POE port) before servicing IP67 Base Station.
Do not work on the system or connect or disconnect cables during periods of lightning activity.
This device is not designed or approved to be used in any Hazardous Locations. Do not install or
operate device if area is known to be an explosive environment.
Externally ground this equipment using a customer-supplied ground wire before applying power.
Contact an electrician if you are uncertain that suitable grounding is available. Refer to Installing
the Ground Wire instructions. < All wall mounting installations are subject to the acceptance of
local jurisdiction.
Do not locate antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme
care not to come into contact with such circuits, because they may cause serious injury or death.
For proper installation and grounding of the antenna, please refer to national and local codes.
CAUTION:
Power over Ethernet (PoE) Certification does not apply or extend to voltages outside of standard PoE
range. Any PoE voltages beyond 0vdc to 60Vdc have not been evaluated by UL or MULTITECH. Nominal
PoE voltage is 48Vdc to 57 VDC. The end user supplies the PoE cable. If the cable is to be used
outdoors, the cable must be certified for outdoor or burial use.
For models:
MTCDTIP-270x-xxx, MTCDTIP-275x-xxx
For models:
28
Cautions
Recommended PoE: 802.3bt-compliant Type 4 Class 7 Power-over-Ethernet (PoE) Powered
Devices (PDs) and require PoE Power Supply Equipment (PSE) that is 802.3bt-compliant with
minimum 60W output power capability.
Conduit
®
Base Station IP67 Getting Started Guide for Versions 1.5 and 2.1
Advertisement
Table of Contents
Need help?
Do you have a question about the Conduit Series and is the answer not in the manual?
Questions and answers