Multitech SocketSLIC TBR21 Specification Sheet

SocketSLIC
Analog Telephony Interface Module
The SocketSLIC ® interface module is a complete, ready-to-integrate isolated and programmable analog-to-PCM
interface. It allows the user to choose the appropriate telephony interface when the system is configured either
in manufacturing or in the field. This flexibility adds convenience, low cost and quick time to market to designing
modern communication systems or updating existing telephony systems. The SocketSLIC interface module takes
care of the many standard analog interfaces allowing the designer to focus on the digital design.
Features
• Analog port supports standard telephony interfaces
• Digital port supports standard TDM interfaces
• Control port supports standard serial interfaces
• Supports FXO, FXS, DPO, DPT, E&M, PLR, ETO, TO
• Loop-Start, Ground-Start, Direct-Inward-Dialing (DID)
• E&M Type I, II, III, IV and V signaling
• Two-wire and four-wire transmissions
• Supports Caller ID service and other CLASS services
• Provides loop-disconnect signals
• On-board ring generator and power supply
• Adjustable telecom battery voltage
• Adjustable transmit and receive levels
• Adjustable ringing voltage and ringing frequency
• FCC Part 68, CS-03, TBR21 approved
• No DIP switches or jumpers
• Single +5VDC supply voltage
• Low power consumption
• Small footprint
®
Benefits
• Field Programmable
• Operating System Independent
• Bellcore Compliant
• Isolated Analog Telephony Interface