mangOH Red Manual page 42

9. Install the mangOH Red platform on your mangOH board:
$ instsys mangOH_Red.wp85.update 192.168.2.2
If the applications install successfully, the last message shown will be "SUCCESS
Note:
If the target has any problems starting the mangOH Red platformat applications, it automatically reboots and
restores to its original state (prior to the instsys command). If this happens, the target will not be reachable whlie it is
rebooting.
10. After the installation is done, open a terminal window and connect to the mangOH Red:
$ ssh root@192.168.2.2
11. By default, redSensorToCloud is installed but not started. Start the application to send data to AirVantage:
# app start redSensorToCloud
Note:
redSensorToCloud automatically opens a data connection, so you do not need to use "cm data connect".
In your AirVantage account, you will start to see sensor reports appearing on your new schedule—on the
Timeline screen you can compare the timestamp intervals for new reports compared to reports received before
you made your changes as shown in the following figure. (To see new reports received while this screen is
being viewed, click the Sync. status icon.)
Rev 3 9/21/17
A.1.2: Update an Installed Application
42
Done".