mangOH Red Manual page 24

iii. Display information about the CF3 module and confirm that the Firmware version shown is the one
that you downloaded:
# cm info
n
iv. Disconnect from the mangOH Red:
# exit
6. Change directory to the mangoh work directory:
$ cd $MANGOH_ROOT
7. Build the mangOH Red platform:
$ make red_wp85
Note:
• This may take several minutes to run.
• The number of packages listed will vary (newer platform releases will have different numbers of files).
Note:
In the command "make red_wp85", 'wp85' indicates the target type on which the applications will run. If a
different module type is used, the make command must be modified to indicate the correct type. For example, if the
CF3 module is a WP7602, the target must be changed from "wp85" to "wp76". This applies to all make commands
described in this guide.
8. Verify that the update file mangOH_Red.wp85.update was created:
$ ls -al *.update
Rev 3 9/21/17
5.1: Build and Install Legato Platform and mangOH Red Platform on Target
24
IMEI
FSN
Firmware version