Connect To Mobile Networks; Connect To A Mobile Network - mangOH Red Manual

6: Connect To Mobile Networks

In this chapter, you will learn how to connect the mangOH Red to a mobile network. When the mangOH_Red has
a data connection, you can transmit data, including on-board sensor readings, to the IoT cloud.

6.1 Connect To a Mobile Network

To connect to a mobile network, you must have an activated micro-SIM in the mangOH Red.
Note the location of the notched corner.
1. If you do not have a micro-SIM in the mangOH Red, insert one before continuing:
a. Disconnect the power from the mangOH Red (remove the jumper from the power header, or unplug the
micro-USB cable that is providing power).
b. Insert a micro-SIM in the slot on the bottom side of the mangOH Red. You can use the Sierra Wireless
micro-SIM that is included in the kit, or another micro-SIM that has been activated by a mobile network
provider.
c. Reconnect the power (plug in the micro-USB cable or insert the jumper on the power header on the same
pins it was removed from in
Note:
You must disconnect the power before switching SIMs so the mangOH_Red can detect the SIM
while powering on.
2. Connect to the target:
a. On the dev machine, open a terminal window.
b. Connect to the target:
$ ssh root@192.168.2.2
Rev 3 9/21/17
Inserted in bottom part of slot
step a. The Power LED will light immediately.
27
6