Yamaha T115SE 2019 Owner's Manual page 64

1. Bulb
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by turning it clockwise.
6. Install the cowlings.
PERIODIC MAINTENANCE AND MINOR REPAIR
Replacing a turn signal light bulb
or the tail/brake light bulb
1. Outer lens
2. Outer lens screw
3. Side cover
1. Remove rear panel and side co-
ver (see page 6-7)
2. Remove the 2 pcs lens by remo-
ving the screws.
3. Remove the burnt-out tail/brake
light bulb by pushing it in and
turning it counterclockwise
6-30
1. Inner lens
2. Inner lens screw
Remove the burnt-out rear turn
light bulb by pulling it out.
4. Insert a new bulb tail/brake light
into the socket, push it in, and
then turn it clockwise until it stops.
Insert a new bulb rear turn in to
the socket.
5. Install the lens by installing the
NOTICE:
screws. Do not over-
tighten the screws, other wise
the lens may break.
6. Install side cover and rear panel.
6