Yamaha T115SE 2019 Owner's Manual page 45

PERIODIC MAINTENANCE AND MINOR REPAIR
1
1. Engine oil drain bolt
To change the engine oil
1. Start the engine, warm it up for
6
several minutes, and then turn it off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and drain bolt to drain the oil, from
crankcas e.
NOTICE :
Before installing the engine oil drain
bolt, do not forget to install the
washer bolt.
1. Bolt
2. Oil filter element cover
TIP :
Skip step 4-6 if the oil filter element is
not being replaced.
4. Remove the oil filter element cover
by removing the bolts.
5. Remove and replace the oil filter
element and O-ring.
6-11
1
2
1. Oil filter element
2. O-ring
6. Install the oil filter element cover by
installing the bolts, then tightening
them to the specified torque.
Tightening torque:
E ngine filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP :
Make sure that the O-ring is properly
seated.
7. Install the engine drain bolt, and
then tighten the drain bolt to the
specified torque.