Replace A Magazine; Unlock A Magazine With Ocp Or Rmi - Overland Tandberg NEO S Series Service Manual

NEO S-Series Library Service Manual
b. Slide the power supply into the library (1) until it is flush with the back panel of
c. Finger-tighten the blue captive thumbscrews (2) to secure the power supply.
d. Attach the supplied AC power cord to the new power supply and plug it into the
6. Press the Base Module power button for one to two seconds to power on the library.

Replace a Magazine

WARNING:
power cords while working with the library.
WARNUNG:
ziehen Sie stets den Netzstecker, bevor Sie an der Einheit arbeiten.
AVERTISSEMENT:
toujours les cordons électriques en travaillant avec l'appareil.
CAUTION:
precautions to prevent damage to micro-circuitry or static-sensitive devices.l

Unlock a Magazine with OCP or RMI

NOTE: As a best practice, perform this procedure while applications are idle. While the magazine is
Unlock the magazine using the OCP or RMI. Only one magazine or mailslot can be open at a
time.
NOTE: If these methods fail, or if a magazine needs to be removed when the power to the device is
1. Open the magazine access door.
2. Log in as an administrator in OCP or RMI.
3. Unlock the magazine.
NOTE: If not removed, the magazine and mailslot will relock after 30 seconds.
10400666-005
the library.
same AC circuit previously used.
To reduce the risk of electric shock or damage to equipment, always remove any
Um das Risiko eines elektrischen Schlags oder Schäden am Gerät zu vermeiden,
Pour réduire le risque de choc électrique ou endommagement de l'équipement, retirez
While working with the library, observe standard Electrostatic Discharge (ESD)
extended, the library robotic assembly cannot move media.
off, you can release the magazine manually. See
©2015-20 Overland-Tandberg
Remove the Magazine Manually on page
Replacing Parts
29.
28
