Replace A Power Supply - Overland Tandberg NEO S Series Service Manual

NEO S-Series Library Service Manual
5. Finger-tighten the blue captive thumbscrews to secure the power supply.
6. Attach the supplied AC power cord to the new power supply.
7. Plug the power cord into a different AC circuit than the other PSU to operate in
failover mode.
8. Press the power button to power the library back on.

Replace a Power Supply

1. Use the PSU LEDs to locate the failed power supply on the rear of the library.
2. Verify that all host processes are idle and power off the library by depressing the power
button on the front panel.
3. Unplug the AC power cord from the PSU being replaced.
4. Remove the old PSU:
a. Finger-loosen the three blue captive thumbscrews on the power supply.
b. Using the thumbscrews, slowly pull the power supply approximately 4 inches (10
c. While using one hand to support the bottom of the power supply, completely remove
5. Install the replacement PSU:
a. Position the new power supply onto the alignment rails in the bay.
10400666-005
AC Power Plug
cm) out of the library.
the power supply from the module and set aside.
©2015-20 Overland-Tandberg
Replacing Parts
27
