Reinstall The Tape Magazines; Reconnect Cables And Verify Firmware Version; Package Chassis For Shipment - Overland Tandberg NEO S Series Service Manual

NEO S-Series Library Service Manual
4. Secure the chassis to the rack with the captive screws on both side flanges.
5. After the appliance is secured in the rack, verify that all drives are secure in their bays
and have not become unseated.

Reinstall the Tape Magazines

1. Supporting the magazine underneath, position the magazine rails onto the alignment
rails in the appropriate bay.
2. Using the handle, push the magazine slowly into the library until the magazine release
latch snaps into place.
The magazine automatically locks into place when it is correctly installed.
3. Repeat

Reconnect Cables and Verify Firmware Version

1. Reconnect all the cables to the same ports from which they were removed.
2. Reattach the power cords.
3. Press the Base Module power button for one to two seconds to power on the library.
The green LED is shown when the library completes its Power-on Self-test (POST).

Package Chassis for Shipment

WARNING:
rack installation or removal to prevent injury.
WARNUNG:
Deinstallation die Nutzung einer mechanischen Hebehilfe (oder mindestens zwei Personen).
AVERTISSEMENT:
au moins) soit utilisé lors de l'installation ou de l'enlèvement du support.
CAUTION:
label is replaced from the rear panel on the top cover of the library.
10400666-005
Steps 1–2 for the remaining magazines.
It is recommended that a mechanical lifter (or at least two people) be used during
Um Verletzungen zu vermeiden, empfehlen wir zur Rack-Installation oder -
Pour éviter toute blessure il est recommande qu'un monte-charge (ou deux personnes
Before transport the library, it is recommended that the shipping lock and the yellow
©2015-20 Overland-Tandberg
Replacing Parts
32
