Advertisement
Unit #1
Fig. 4
O
AC POWER
R
SUPPLY
C
FOR AC-VERSION
(MULTI HOOK-UP); Fig. 4 and Fig. 4a
1. Remove COVERS from all ENCLOSURES (2).
Fig. 4 and Fig. 4a.
2. Remove SOLID BLACK PLUG GROMMET (17) from
left side of all ENCLOSURES (2). Replace with GRAY
GROMMET (18). (Supplied with each Faucet).
Fig. 4 and Fig. 4a.
3. Feed the EXTENSION CABLE (3) from the Faucet
through GROMMET (4) and connect it to the
SOLENOID CABLE (5). Fig. 4 and Fig. 4a.
4. Feed the EXTENSION CABLE (8) from the Faucet
through GROMMET (4a) and connect to either of the
two terminals at the one end of the Y-ADAPTER (13).
Connect the 10 ft. EXTENSION (11a) to the other
terminal at the same end of the Y-ADAPTER (13).
Fig. 4 and Fig. 4a.
5. Feed the other end of the 10 ft.EXTENSION (11b)
through the two GRAY GROMMETS (4a and 4b) and
connect to the single terminal end of the next unit's
Y-ADAPTER (13). Place Y-ADAPTER (13) into
ENCLOSURE (2) as shown in Fig. 4 and Fig. 4a.
6. Repeat Steps above for each additional Unit, for a
Max. of 15 Units on one AC POWER SUPPLY.
7. Replace ENCLOSURE COVERS. Tighten cover
screws firmly.
10 ft. EXTENSION
CABLE
OR
4" (102mm) SQ. X 3-1/2" (89mm) DEEP ELECTRICAL BOX
Hubbel-RACO #256 OR EQUAL (BY OTHERS).
Unit #2
10 ft. EXTENSION
*MAXIMUM OF 15 UNITS PER AC POWER SUPPLY.
10' MAXIMUM CABLE LENGTH BETWEEN UNITS.
YOU CAN USE EITHER THE PLUG-IN
OR HARD-WIRED TRANSFORMER.
Fig. 4a
11a
8
17
18
13
8
Unit #3
CABLE
Unit #1 Detail
5
3
AC POWER
YOU CAN USE EITHER THE PLUG-IN
OR HARD-WIRED TRANSFORMER.
4a
4b
11b
2
4
M 9 6 5 6 13
Advertisement
