Advertisement
2
INSTALL SUPPLY ELBOW
ASSEMBLY & ENCLOSURE;
Fig. 7 and Fig. 7a
1. Install HOSE CLAMP (22) onto SPOUT HOSE (15).
Install SPOUT HOSE (15) onto ELBOW NIPPLE (23).
Fully tighten HOSE CLAMP (22) to secure SPOUT
HOSE (15) to ELBOW ASSEMBLY (24). Fig. 7.
2. Using the ANCHORS (25) and SCREWS (26) supplied,
attach ELBOW ASSEMBLY (24) to finished wall, covering
the hole in wall. Fig. 7 .
3. Remove ENCLOSURE COVER (27). Feed EXTENSION
CABLES (5b) THROUGH GROMMET (28) in back of
ENCLOSURE (29). (Refer to VIEW "A"). Hold the
ENCLOSURE (29) so that it covers the wall opening and
mark the four mounting hole locations as shown. Fig. 7a.
4. It is recommended that the ENCLOSURE (29) be secured
to a wall stud or cross brace within the wall using the
SCREWS (30) supplied. If the ENCLOSURE (29) is to be
installed on tile or plaster walls, the ANCHORS (31) and
SCREWS (30) should be used.
CONNECT SPOUT HOSE TO
3
ENCLOSURE; Fig. 8
1. Connect G 1/2˝ end of SUPPLY HOSE (32) to the
ELBOW ASSEMBLY (24). Tighten with adjustable
wrench to make a water tight connection.
2. Connect G 3/8˝ end of SUPPLY HOSE (32) to nipple
on top of ENCLOSURE (29). Tighten with adjustable
wrench to make a water tight connection.
3. IMPORTANT: INSERT FIBER WASHER (33)
INTO SUPPLY NUT (34) ON ENCLOSURE (29).
4. Connect FLEXIBLE SUPPLY (35) to bottom SUPPLY
NUT (34). Connect other end directly to wall supply.
Connection is G 3/8" compression.
Note: FLEXIBLE SUPPLY (35) measures 20" from the
bottom of the ENCLOSURE (29) base. If additional
supply length is required, installer must purchase parts
separately. If FLEXIBLE SUPPLY (35) is too long, loop to
avoid kinking.
NOTE: If using Mixing Valve (optional) See Sheet
#M968808 for installation instructions.
22
Fig. 7
15
23
24
26
Fig. 7a
30
27
28
VIEW "A"
Fig. 8
ELECTRICAL BOX
FOR HARDWIRE
INSTALLATION
(supplied by others)
29
24
34
33
9" TO 12"
(229mm TO 305mm)
5
25
31
A "
W "
V I E
29
5b
LAVATORY RIM OR
MOUNTING SURFACE
COLD WATER OR
TEMPERED
WALL SUPPLY
32
35
M 9 6 5 6 13
Advertisement
