American Standard SERIN T064.342 Installation Instructions Manual page 5

ALIGN SPOUT ASSEMBLY;
1d
Fig. 5
1. Align and push SPOUT (12) through hole, loosely
installed MOUNTING FLANGE (8) and MOUNTING
PLATE (10).
2. Once MOUNTING FLANGE (8) is aligned with
MOUNTING PLATE (10) opening, tighten the three
MOUNTING FLANGE SCREWS (9). (Tighten each
screw little by little to avoid missalignment!)
3. Align and slide and COMPRESSION SEAL (14) and
COMPRESSION RING (13) to MOUNTING FLANGE (8).
SECURE SPOUT ASSEMBLY;
1e
Fig. 6
1. Once MOUNTING FLANGE (8) is installed, move the
SPOUT (12) in or out to determine desired spout length
from finished wall. Note: The Min. is 150mm, (5-7/8)
and the Max. is 225mm, (8-7/8) from the finished wall
to center of the spout end.
2. Tighten COMPRESSION RING (13) to MOUNTING
FLANGE (8) by tightening the three COMPRESSION
RING SCREWS (20) with HEX WRENCH (21) supplied.
This will fix SPOUT (12) length from finished wall.
3. Push ESCUTCHEON (11) to MOUNTING FLANGE (8)
and hand tighten to complete spout installation.
Fig. 5
SPOUT LENGTH
150mm - 225mm
MIN. (5-7/8) - MAX. 8-7/8
8
13
12
14
12
Fig. 6
11
4
10
9
8
14
13
13
12
21
m m
/ 8
8 - 7
2 5
- 2
X .
M A
m
0 m
) -
1 5
7 / 8
( 5 -
N .
M I
9
10
20
8
M 9 6 5 6 13