Advertisement
Installation Instructions – Define S122-125 Suspended LED Luminaire
Attach strain relief to SJ Cord and pull SJ cord through access
plate to lock SJ cord in place on access plate.
Once power and dimming wires are connected, push the wiring
back into the fixture and re-attach the access plate. Individual
fixtures will have the diffuser and diffuser end caps already
installed. For rows, remove the diffuser and diffuser clip and set
aside. Row fixtures require internal joining so the diffuser must
be removed and re-installed after row installation is completed.
7
Connect power and dimming wires using provided push in
connec tors and stuff back into fixture.
3
5
Installation Instructions – Define S122-125 DP/RDP/DIP/RDIP
IL524025EN
www.eaton.com
Connect power and dimming leads to SJ cord as required using
wire nuts (by others)
6
FOR CONTINUOUS ROWS ONLY: Hang far end of the next
fixture in the row using the griplock
cable. Temporarily support the other end.
8
Alignment Pins
Use the Cast Joiners, alignment pins, and fixture tongue to align
and guide the fixtures together.
4
and pre-installed aircraft
®
Fixture Tongue
Cast Joiner
Advertisement
