Connecting Of The Antenna; Antenna Connector Ant1, Ant2, Div1, Div2, Gps And Wifi - Advantech Bivias v2 User Manual

5.7.3 Antenna connector ANT1, ANT2, DIV1, DIV2, GPS and WiFi

Both of main antennas and also both of diversity antennas are connected to Bivias v2
router using the SMA connector on the front panel. There is also available one SMA antenna
connector using which GPS antenna can be connected (applies only to versions with LTE
module). In case that the WIFI expansion port is equipped, reverse SMA connector (R-SMA)
is used.
The router can not operate without connected both of main antennas designated as ANT1
and ANT2!
ANT1 and ANT2 connectors are used to connect main antennas of this router. For con-
nection of diversity antennas are used DIV1 and DIV2 connectors. GPS antenna is connected
using the connector of the same name. On user's request, this router can be equipped with
WiFi connector for connecting corresponding antenna.
The antenna is connected by screwing this antenna to the SMA connector on the front panel
of the router (see figure below).
Diversity antenna improves radio features of the router at low signal strength.
Figure 13: Connecting of the antenna
17
Bivias v2