Table of Contents
Advertisement
5
Apply a generous bead of silicone caulking to the base of the tub. (See Fig. 5)
6
Carefully set the tub into position. Ensure that drain tail piece gasket is fully
seated against the tail piece ange.
Connect the tail piece to the tub drain. Tighten all of the drain connections.
Remove any excess caulking where the tub meets the oor.
Note: Connecting the tail piece assembly to the drain will require access from
beneath the tub.
7
Fill the tub with water and drain. Check for leaks and re-tighten connections
as necessary.
8
Apply a bead of Tub & Tile caulk around the bottom edge of the tub where
it meets the oor. Remove any excess caulking.
FIXTURES
No xtures can be mounted on the tub deck of freestanding tubs. Floor or wall-mounted xtures are required.
Wall-Mounted - The position of the tub and the reach of the spout are critical. Pay special attention to the
spout reach when choosing your xtures. Be careful to ensure the spout will extend out far enough to clear
the tub ange and the falling water will not hit too high up on the side wall of the tub and splash.
Floor-Mounted - Some freestanding xtures must be anchored to the tub drain for stabilization. The waste
and over ow on freestanding tubs are concealed so anchoring to the over ow pipe (or tub structure) is not
possible. Many kits (with minor modi cation) can be mounted to the wall (rather than the drain pipe) for stabilization.
FIG. 5
- 7 -
754988-100 REV. B (5/15)
Advertisement
Table of Contents
