Extron electronics USP 405 User Manual page 5

im Vertrieb von
Output menu
2
Input
Configuration
MENU
2
Output
Configuration
Memory Presets menu
3
Output
Configuration
3
Memory
Presets
Advanced Configuration menu
4
Output
Configuration
MENU
Advanced
Configuration
Either Adjust knob is used
to adjust the submenus*
www.camboard.de
CAMBOARD Electronics
Resol 1024 x 768
NEXT NEXT
Refresh @ 60
Scaler output rates
• See the table in the "Output Configuration"
section of chapter two for available
combinations of resolutions and refresh
rates.
Default: 640x480, 60 Hz
Lock = Accu-RATE Frame Lock™
NOTE
MENU
Save Preset
NEXT
<N/A> 1 2 3
Saving (Save) memory presets
• Save the currently selected input's
sizing and centering information.
• Up to 3 presets per input can be
selected < > (N/A is the default) and
saved.
• Save a preset by pressing the Next
button.
Edge Smoothing
OFF <ON>
NEXT
Encoder Filter
06
NEXT
NEXT
Blue Mode
<OFF> ON
NEXT
Test Pattern
Off
NEXT
Tel. 07131 911201
Fax 07131 911203
Output Signal
NEXT
H Neg
RGB
Video types
Polarity combinations
• RGB (default)
• H-/V- (default)
• Y, R-Y, B-Y
• H-/V+
Erase Preset
NEXT NEXT
<N/A> 1 2 3
Erasing (Erase) memory presets
• Erase the currently selected input's
saved sizing and centering
information.
• Up to 3 presets per input can be
selected < > (N/A is the default)
and erased.
• Erase a preset by pressing the Next
button.
Smooth edges
Top Blanking Bot
• On (default)
021
• Off
NEXT
Encoder filter setting
RGB Delay
• 0 thru 12 (default is 6)
0.2 Seconds
to adjust sharpness
NEXT
Display blue and sync only
Enhanced Mode
• On
<OFF>
• Off (default)
NEXT
Set test pattern type
Press and Hold
• Off (default) • Alt pixel FREEZE to Reset
• Color Bars • Film aspect 1.78
NEXT
• Crosshatch • Film aspect 1.85
• 4 x 4 crosshatch • Film aspect 2.35
Input 2 PAL Film
• Grayscale • Ramp
<OFF> ON
• Crop
NEXT
ce-info@camboard.de
Sync Polarity
NEXT
V Neg
• H+/V-
• H+/V+
*
Top and Bottom Blanking
• Top blanking ranges from
030
000 (default) to 237
• Bottom blanking ranges
000 (default) to 237
RGB delay time
(in seconds)
• 0.0 to 5.0 seconds
in 0.1 sec. increments
(0.7 second default)
Enhanced mode (gain control)*
ON
• On (default)
• Off
To reset the scaler, press
and hold the Freeze button
until reset message displays
NOTE Adjust knobs do not affect
this submenu.
PAL Film Mode
• On
• Off (default)
*
If the Test Pattern is set "On",
"Not Available" is displayed.
USP 405 • Quick Start QS-3