Advertisement
Internal Mounting -
Trim Plate Kit
1
For Internal mounting using the trim plate kit,
please perform the following steps:
1.
Locate a space on the machine that will
properly accommodate the WaveReader.
2.
Using the template supplied on this page, cut
out the area inside the dashed lines [1]. The
opening should be 3" square . The darker
gray circles can be used a drill locations. After
drilling, a jig-saw can be used to finish the
cuts.
3.
Alternatively, you can drill the center hole [3],
and use a 3" circular punch to remove the
area marked by the dashed, interior circle [2].
4.
After making the cut, attach the WaveReader
to the Surface Mount Cover Plate (1) with the
four screws (3) provided in the kit.
5.
Insert the WaveReader & Front Plate through
the opening.
6.
Attach the Rear Backing Plate (2) with the
two nuts (4) provided in the kit, and finger-
tighten.
7.
Make sure to level the Wave Reader and
Front Plate on the machine and fully tighten
the Rear Backing Plate nuts with a 11/32" Nut
Driver or Socket.
3
www.heartlandMicroPayments.com
2
4
Note: For all stack
Speed Queen
models, this process
must be performed
TWICE per
machine.
Make sure there is enough
room to accommodate two
readers!
Trim-Plate Mounting
Template
7
Advertisement
