Advertisement
Installation
On the main panel,
connect J3 of the
5
WaveReader harness to
the H5 connector on the
Speed Queen control
board, in the yellow box.
On some Quantum control
boards, the connector may be
labeled H4.
6
On the main panel,
connect J3 of the
WaveReader harness
to the H1 connector
on the Speed Queen
control board, in the
yellow box.
On the control board locate
7
the plug where the coin
drop is connected. It
should be a small three (3)
pin plug that routes out of
the H3 connector from the
control board.
Disconnect it.
www.heartlandMicroPayments.com
11
Advertisement
